Bose SoundWear Companion Speaker Acoustics and DSP

Bose_SoundWearCompanion_Photo_Xray2

Acoustics and DSP
Time to put on your thinking caps, this gadget is pretty weird.

I'll forgo my normal measurement section as I'm not well set up for measuring this device, but I did do some measurements to confirm some interesting aspects of the SoundWear Companion that I'll talk about here.

The left speaker plays directly into the left ear, but the rear of the left speaker is ported into a waveguide—a tube running through the neckband—and comes out the port on the right hand side next to the right speaker. And vice versa with the right speaker. The purpose of these waveguides is to provide stronger bass response than a small driver would deliver unaided.

First, you must remember the acoustic signal from behind the speaker is out of polarity (180 degrees out of phase) from the signal coming out in front of the speaker. Second, it travels through the waveguide about one foot before it comes out the port on the other side, causing a delay of about just under 1msec.

Bose_SoundWearCompanion_Graph_60HzSQWLeftOnly

The above plot is of the leading edge of a 60Hz square wave being played in the left channel (blue) only. It's zoomed in to show just the negative going transient edge which occurs at about 3.9msec in the plot. Note that this transient is somewhat "M" shaped with positive going humps to either side of the main negative going spike. I have to assume that this is an artifact of all the DSP (digital signal processing) going on. Yeah...this is a complicated widget, and we're peering through a glass very darkly here. I would have loved to be a fly on the wall as Bose engineers discussed how this product really works.

There is no signal going to the right channel (red); the right ear is mainly hearing the sound coming out the port that originates behind the left speaker. You can see the positive going transient from the square wave at about 4.8msec in the plot. Note that it is inverted and delayed about 1msec.

But! You can also see two smaller transients prior at about 4msec and 4.5msec. I suspect we may be seeing sound from the left speaker that has travelled through the air under the chin and behind the neck to reach the right ear. Yet more complication to consider.

Let's let that sink in and move on.

In most music material, the bass is close to the same on both channels and is in phase (in polarity) on both channels. That means that when low frequencies are driving both drivers, the sound exiting the ports (which is out of phase because it is coming from behind the opposing speaker) will be out of phase with the adjacent driver and would cause cancelation at the ear. Here's an example:

Bose_SoundWearCompanion_Graph_70HzSineLeftOnly

In the plot above, the left channel only (blue) is being driven by 70Hz sine wave. The right ear (red) is hearing mainly the response from the port. You can see that it is out of phase.

Bose_SoundWearCompanion_Graph_70HzSineBoth

But, in the above plot, when I turned on the other channel so both were being driven, I found that the right channel was out of polarity with the left channel so that it was reinforced by inverted acoustic signal from the waveguide port, and delivered an increased response.

From paragraph 0008 of the patent:

Embodiments may include one of the following features, or any combination thereof. The first and second acoustic drivers may be driven such that they radiate sound that is out of phase, over at least some of the spectrum.

And in paragraph 0031:

Accordingly, each ear directly receives output from the front of one driver and output from the back of the other driver. If the drivers are driven out of phase, the two acoustic signals received by each ear are virtually in phase below the fundamental waveguide quarter wave resonance frequency, which in the present non-limiting example is about 130-360Hz. This ensures that low frequency radiation from each driver and the same side corresponding waveguide outlet, are in phase and do not cancel each other. At the same time the radiation from opposite side drivers and corresponding waveguides are out of phase, thus providing far field cancellation. This reduces sound spillage from the acoustic device to others who are nearby.

Hoo boy. To recap: At low frequencies, the left and right speaker are being driven out of polarity with each other so that the ports reinforce bass at the ear, and also so that the low notes cancel out at a distance making the device seem less loud to others. We'll get to how this sounds a little later.

If you've followed along thus far you may be able to predict what's next. At 500Hz the waveguide will be about a half wavelength long. That means by the time the signal from behind on driver makes it though the waveguide to the opposite side it will be back in phase with the driving signal.

Bose_SoundWearCompanion_Graph_500HzSineLeftOnly

The plot above shows a 500Hz signal from the left speaker (blue), and the signal being radiated from the port on the right side (red). As you can see, it's back in phase with the left channel after going through the acoustic half wavelength delay of the waveguide.

Bose_SoundWearCompanion_Graph_500HzSineBoth

And, low and behold, when I turn on the right channel (plot above) it's back in phase with the right channel. So, somewhere between 130-360Hz, according to the patent, the DSP swaps the phase of the drivers.

I have to tell you I tried this at a number of different frequencies and when only one channel was driven results were as expected in terms of phase and delay. But when I turned on the other channel, sometimes it remained lagging at the passive phase angle...sometimes it snapped into phase...and sometimes it went 180 out. The more I probed, the more confused I got.

When I tried a square wave, the response was completely un-square wave looking.

Bose_SoundWearCompanion_Graph_100HzSQWLeftOnly

Above is a 100Hz square wave with the Bluetooth signal being sent to the left channel only. All I can tell you is that it did sound basically like a square wave, and it did sound like it was coming from the left in the acoustic image around my head, but it didn't sound like it was coming from a speaker under my left ear.

I did check for is sound coming out the right speaker with the left channel only driven, and there was signal coming from the speaker, but at a somewhat lower level than the left side. Also, using a square wave you could tell it was generally higher frequency information.

What I noticed most was that it was difficult to separate what I was hearing from the speaker with the acoustic output from the nearby waveguide port. There was plenty of bass energy, but the port was very wide band as well—there was quite a bit of higher frequency energy coming through.

It may be that Bose engineers are using both DSP crossfeed and the acoustic crossfeed through the waveguide to provide the inter-aural time delay (ITD) to improve imaging.

ITD is the main cue you listen to to tell how far something is left to right. Normal ITD for 30 degree off axis speakers is about 300-400usec; ITD for something 90 degrees at your side is about 600usec; the waveguide on the SoundWear Companion is 1000usec. It's too long, but not by too much, and it's inverted..who knows?

While it's way beyond the scope of this review—and my skills—to reverse engineer the SoundWear Companion to figure out exactly what's going on, it does seem obvious to me Bose is playing all sorts of DSP tricks with psychoacoustic cues to get this thing to deliver some bass response and to cause the perceived acoustic image to rise up away from the shoulders, which it seems to do quite well. This thing is an acoustical mystery machine.

Let's take a look at frequency response. I measured frequency response both with a swept sine wave and with pink noise with FFT analysis.

Bose_SoundWearCompanion_Graph_FRLeftSweep

The above plot is the measured frequency response using a swept sine wave to the left channel only. The left channel (cyan) is remarkably even it seems to me; the right channel (red) is significantly more uneven, probably filled with DSP cues. The left channel response does rise quite a bit too steeply through the midrange and low treble to a roughly 5dB too high peak at 4kHz. This response would be quite bright and too forward.

Bose_SoundWearCompanion_Graph_FRLeftPink

But with pink noise driving the left channel only, the left side response (in green—sorry about the color change) is much closer to a ear drum reference point target responce. The undriven right channel also seems to have a bit more energy in general than it did with the sine sweep.

Bose_SoundWearCompanion_Graph_FRStereoSweep

With both channels driven by a sine sweep, the channels are quite similar but the measurement on the whole is again too bright...but not quite as bright as the left channel when driven on it's own!

Bose_SoundWearCompanion_Graph_FRStereoPink

The picture again changes when uncorrelated pink noise is used to drive both channels. While the plots are somewhat noisy—in part due to the pink noise itself, but likely also caused by the DSP psychoacoustic cues being generated—the plot on the whole is remarkably well behaved and close to target.

The important observation here is that these cans measure differently depending on the signal driving them, and with a complex signal driving both channels it measures fairly well.

One minor thing to note here is that there is a dip feature on the left channel between 200Hz and 400Hz on all measurements. I suspect this is an artifact from the in-phase to out-of-phase reversal in the bass. Not sure why it happens only on the left channel, but would guess that it's one of those "it's as close as we can get it" engineering compromises. I don't think I heard it in particular...speaking of which...

Let's get to how things sound!

COMPANY INFO
Bose Corporation
The Mountain
Framingham, MA 01701
1-508-879-7330
ARTICLE CONTENTS

COMMENTS
tony's picture

The Technology Curve is getting steeper!

Something you didn't suggest in 'your daily use description' of these devices was a comment about 'what percentage of the Day' were these things useful? I'd say that I'll wear my LG Tone for 90% of my working/waking hours, I have a ( never been used ) back-up.

Shure are making a headset using their 215 but also able to use their 535 and 846 in-ear monitor.

Geez, I see this segment getting some Style Attention, hmm, how long before they're on the Front Cover of GQ, being worn by Anderson Cooper or someone else, doing: Product Placement?

I still have uses for my wireless Sennheiser headphones but for how much longer?

Tony in Michigan

ps.. Onkyo & Pioneer have just released little Digital Audio Players with MQA, these devices seem like having an entire 1980s front end music system in the palm of your hand ( include having TTVJ's entire 12,000 vinyl collection on SD memory cards ) phewwwww.

ps.2, those Europeans, like Goldmund & DynAudio, are getting serious about going Wireless & Active.

Phoniac's picture

They forgot the Mute button...

AndreasCY's picture
wiinippongamer's picture

There's one product category that serves the same use cases even better: Wireless IEMs

Tyll Hertsens's picture
But you can't hear what's going on around you.
brause's picture

..and then the same old same old: when battery has been consumed after 3-4 years, one can throw it away and people have to buy another one. That's how Apple, Bose, and Co. create repeat customers.

Glad I still have two noise-cancelling earphones that run on a (rechargeable) AAA battery.

Thank you Bose - too expensive in the end.

Corsair's picture

Tried it in the bose store. Comfy and surprisingly good sound. Certainly good for doing the dishes, laundry, talking on the phone. You don't always want to put in and take something out of your ears. This is far less intrusive. Even custom fit or "comfy" iem's are not appealing to me. Will I buy this new bose product? Hell no, not even at a used price. I have better things to spend my hard earned cash money on, but it was fun trying it out, and I bet it will make a lot of users happy.

Harry Manback's picture

We have new Sennheiser HD660s headphones and you are reviewing a gadget?!? Come on Tyll, I value your opinion, please skip the silly gadgets and review the 660s.

Tyll Hertsens's picture
I have my request in, should be relatively soon.
davidmelis's picture

Thank you for your detailed review and for your passion / appreciation of quality music. I read and watched and just now ordered my own SoundWear. Thanks again!

yelero's picture

Tyll, when will you finally review and measure the Sennheiser HD660S?

zobel's picture

How about the new Sennheiser HD600S?

ednaz's picture

Not sure what brand (now that I know this is a "thing" I'll be obsessed with finding out) but a couple of cashiers at a nearby supermarket wear these around their necks. Headphones wouldn't be tolerated by the market (or probably by customers) because they're so obvious and would send a clear "I'm not listening to you" image. I did hear what they were playing, really low level, and it was way better than the pervasive, far too loud Muzak the store plays. I wonder if they are hearing both the blaring Muzak and their own music, simultaneously.

Not sure how I feel about this category of device being worn in jobs where someone's work involves dealing with others. At least the couple times I've seen this, the cashiers weren't tuning out their job or customers, so I didn't really pay too much attention.

This review did get me thinking about them for myself, though. I do photography, and on travel shoots, or when I'm out shooting street photography, there are long periods of time of just hanging out, waiting for the right light, or the right character to wander by. By long periods I mean an hour or two of just hanging out time. These would make that dead time a lot less boring. Headphones, even IEMs, take you too much out of the environment.

shing's picture

Hi, thank you for the in-depth review. I seem to be noticing a touch of lag whereby the movement of mouth is not syncing to the word. I'm connected to a macbook pro touchbar. Is this to be expected?

jimx1169's picture

Heard them at the Bose display at the local Frys. Sounded way better than I expected. The Bose display let me pair them to my phone so I could listen to my own music and I was pretty impressed. As mentioned in the article they won't replace a good pair of headphones for critical listening but they will, for me, replace my computer speakers for everyday listening. I love that I can hear the music but can also hear what's going on around me. For casual listening they're just what I didn't know I was looking for. Wish they were cheaper, though.
Jim

Johnson's picture

Thanks for the detailed review Tyll, I'm gonna check these out. I do tree service Raleigh NC all day and need a something like while I'm working.

Habu2u's picture

Tyll, Nice review of alternative listening gear. You mention "Sonos" throughout you review.

May I ask what Sonos gear you listen with at home?

I considering the simplicity of the Sonos system...

Thank you!

X